Garage door won't close: sensor repair in Bonita Springs

A door that starts down and comes straight back up is nearly always telling you about its safety sensors.

Call (239) 402-1636

In short

A garage door that won't close from the remote is most often a sensor problem, not a broken door. In Bonita Springs, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Ceiling opener and torsion spring over a single garage door

Doors that won't close in Bonita Springs

On Bonita Beach, ground-level garages under raised homes put the sensors right in the path of salt spray and surge, and many were under water in Ian. Inland, in Bonita Bay, Pelican Landing and the communities east of I-75, seasonal owners return to cobwebs, lizards and dust across the lenses after a closed-up summer. A dry cloth and a look at both lights solves a surprising number of calls.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

What the technician does

  1. Checks power and wiring to both sensors and repairs any break.
  2. Realigns the sensors, or replaces the pair if one has failed.
  3. Resets the open and close travel so the door seals without straining.
  4. Tests the automatic reverse on an object in the doorway and with the beam blocked.

Around Bonita Springs

  • Bonita Bay: A large gated community between US 41 and Estero Bay.
  • Pelican Landing: Gated neighborhoods on the north side toward Coconut Road.

See the full Bonita Springs service area.

Door stuck? Call before you try to force it.

A door with a broken spring or cable can drop suddenly. Leave it closed, keep clear, and call. We'll tell you whether it's safe to use and get a technician scheduled.

Call (239) 402-1636
Call (239) 402-1636