Garage door panel replacement in Bonita Springs

Garage doors are built in horizontal sections, and a damaged one can usually be swapped if a matching section is still made.

Call (239) 402-1636

In short

A dented garage door panel in Bonita Springs can usually be replaced without changing the whole door. If the door is old and matching panels are no longer made, or several sections are damaged, a new door can cost little more and is worth comparing.

Panel damage in Bonita Springs

Bonita Springs doors along Bonita Beach Road and the Imperial River saw salt water from Ian's surge, and steel sections that stood in it can rust from the inside out, starting along the bottom edge. A panel that is blistering or swelling there should be replaced before the corrosion reaches the hinges. Because most doors here are wind-rated, any new section has to carry the same rating as the rest of the door. In Bonita Bay, Pelican Landing, Spanish Wells and Worthington, doors are often wide, decorative and specified by the community, so matching color, window pattern and texture is part of the job, and the association may have to approve the result. Golf carts and cars in tight garages dent bottom sections all over town. If only one section is damaged and the door is a current model, swapping that section is usually far simpler than replacing the door.

When one panel can be replaced

A sectional garage door is made of four or five horizontal sections joined by hinges, and each one can be removed and replaced. That works well when the damage is limited to one or two sections and the manufacturer still produces the same model, size, color and pattern. The door's maker and model are usually printed on a label on the inside of a section or on the end stiles. If the door is a current or recent model, a matching section can normally be ordered. If it is twenty years old, the match may no longer exist.

Hit by a car?

Backing into a closed garage door is one of the most common causes of panel damage. Even if the door still opens, check that it runs straight and closes evenly. A hard hit can bend the bottom section and the track, loosen the brackets that hold the track to the wall, and knock the door partly off its rollers. Do not keep using a door that grinds or tilts after an impact. If the damage might be covered by your car or home insurance, take photos before anything is moved, and ask for a written description of the repair.

How a panel replacement is done

The technician first identifies the door's make, model, size and color, then orders the matching section. On the day of the repair, the door is secured and the spring tension is released before any hinge or bracket is undone. The damaged section is taken out, the new one is fitted with its hinges and rollers, and the door is reassembled. Because a new section can weigh a little more or less than the old one, the springs are rebalanced afterwards, and the opener's travel and safety reverse are tested.

Around Bonita Springs

  • Bonita Bay: A large gated community between US 41 and Estero Bay.
  • Pelican Landing: Gated neighborhoods on the north side toward Coconut Road.

See the full Bonita Springs service area.

Door stuck? Call before you try to force it.

A door with a broken spring or cable can drop suddenly. Leave it closed, keep clear, and call. We'll tell you whether it's safe to use and get a technician scheduled.

Call (239) 402-1636
Call (239) 402-1636